Excel G5 Bedienungsanleitung PDF herunterladen (Seite 21)

~ 21 ~

Excel

use

manual

44 Ousegate, Selby, North Yorkshire, YO8 4NH

Tel. +44(0)1757 701177, Fax +44(0)1757 706011, E-mail: sales@vanosmedical.com, www.vanosmedical.com

Adjusting the armrest height (optional armrest)

To adjust the height of this armrest, you have to use the supplied wrench number 4

- Loosen the screw with the supplied wrench, see figure 30

- Move the armrest to the correct height and tighten the screw back down

- Make sure the screw and armrest are both in place

Push handles height-adjustable

- Turn the black lever, until you can move push handles. See figure 31

- Move the push handles to the desired height and tighten the black lever back on

- You should make sure the lever is in a place where it is not an obstacle

- Make sure the handle is in the correct place

Push handles height and angle adjustable

- Turn the black lever, until you can move push handles. See figure 32

- Move the push handles to the desired height;

- Or move the push handle 90˚ inwards so that the overall length on the wheelchair falls. This saves a lot of

space when you take the wheelchair in the car

- Turn back on the black lever

- You should make sure the lever is in a place where it is not an obstacle

- Make sure the handle is put down

5.9 Potential uses and functions of the back of the wheelchair

Using the tension bar

- If your wheelchair folds out the tension bar is the last item to lock into place and may require pulling

upwards to do so. You can move the tension bar by using the nylon loop see figure 33

- If you wish to fold your wheelchair you must first release the tension bar. You can do this by pulling the

nylon loop of the tension bar downwards gently

Using the back tension straps

With eight back straps on the wheelchair, you can fully customize the back of the wheelchair to suit your own body

- Get behind the wheelchair and first remove backrest upholstery that is an independent item that is

attached to the tension straps with Velcro

- When you have removed the backrest upholstery you will see eight straps. These can be adjusted to the

desired tension, simply release the Velcro, put the strap in the desired position and reattach the Velcro

- When you're finished, place the backrest upholstery back and you can use the wheelchair

Figure 30

Figure 31/32

Figure 3

1/32

Figure 33

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 32 33

Keine Kommentare

Excel G5 Bedienungsanleitung Seite 21